Installation and use of the Balanced Body
®
F.I.T. Kit
NOTE
:
The images will show an Allegro Refromer but the same
install applies to studio Reformers with towers.
Parts List
Part Number
Qty
Description
707-214
2
Black ropes
220-011
2
Fit Kit Pulley
607-276
2
Extension straps
1. Remove the existing ropes from the Reformer
2. For an
Allegro Reformer
installation, move your pulleys to
their lowest position.
For a
Studio Reformer
installation, lower your metal risers to
their lowest position. Make sure the detent pin is retaining the
riser in position.
3. Install one F.I.T. Kit pulley.
Locate the pulley assembly
over the desired eyebolt. Push
the pulley assembly in and
hook it onto the eyebolt.
Then release and verify that
the hook is fully engaged
onto the eyebolt. The F.I.T.
Kit pulley can attach to any
eyebolt (other than the top
center one) to create different
angles of pull for different
exercises, and can be moved with the ropes in place.
4. Feed the new longer rope through the F.I.T. Kit pulley, Tower
pulley and finally into the carriage cleats as shown in Figure B
and C.
5. Repeat on other
side and make
sure ropes are even.
Proper installation
should look like
Figure D.
Fig. A: Pulley clip must engage
eyebolt.
Fig. C: Proper orientation of rope
going through cleat.
Fig. B
Fig. D
Contact Us
1-800-PILATES | +1-916-388-2838
pilates.com | [email protected]
400-174 | 06.29.18
Содержание F.I.T.
Страница 2: ...2 ...