Baker SterilGARD III Advance, Руководство оператора

Страница: 60 / 65

Document: 333D012G
5-18-2007
- 59 -
Airflow Monitor (AFM) Installation and Calibration: SterilGARD
®
III Exhausting to
Room, HEC or CEC
Exhaust to Room
1) Remove all items from shipping container and identify the following: Contents should include
Airgate with 1” [25.4mm] probe installed, Airflow Monitor (AFM) and Velcro Strip (If AFM was
not factory installed).
2)
Insert the 1” [25.4mm] long AFM probe into the shaft collar located on top of the airgate if not
already complete. The probe has a long scratch mark on its side. Rotate the probe so the mark is
positioned to the left side of the shaft collar as shown in
Detail A. This will orientate the thermisters
(glass beads) on the probe tip in a horizontal plane so it can properly sense the airflow. Fully insert
the probe so the tip passes through the hole in the airgate approximately 3/32” [2.38mm]. Tighten
the retaining collar set screw carefully. Do not over tighten. (
Make sure not to rotate the probe
while tightening ).
3) Remove the #8-32 hardware already fastened to the two weldstuds on top of the cabinet.
4) Next grasp the Airgate and carefully lower it onto the top seal panel locating the keyhole contour
onto the far left weld stud as shown in Figure 1
. Once in place slide the Airgate to the far left until it
stops. Route probe wiring behind front access panel and plug into AFM. Be sure to tie up extra
probe cord length in order to prevent interference with viewscreen.
5) Next place the Exhaust Filter Protector on top of the unit locating the holes onto the two front
weldstuds and replace #8-32 hardware and tighten.
EXHAUST FILTER
PROTECTOR
TOP OF CABINET
DETAIL C
#8-32
HARDWARE
AIRGATE
DETAIL A
AIRGATE
AFM PROBE
ORIENTATE SCRIBE
MARK AS SHOWN
Figure 1: AFM installed in cabinet venting to room