Baker Panametrics CTF878, Руководство по программированию, Страница: 66 / 88

Chapter 4. Programming Meter Settings
60 Model CTF878 Programming Manual
Note: Pressing [SEL] causes the screen to alternate between a set of upper-case (capital) letters and a set of
symbols. Use both screens to create the desired label.
c. Repeat this procedure for each letter or symbol you wish to add to the label (up to a total of fourteen
characters). If you wish to delete a letter, press [F1] (Delete) to erase each letter or symbol, from right to left
on the label.
d. When you have completed the label, press [F3] (OK) to confirm the label, or [F2] (Cancel) to leave the
window without adding the label.
Note: It is not necessary to enter the “# Data Points” or “Max Points” text boxes.
4. The final prompt asks you to enter or change data in the user table.
a.
Press
[ENTER]
to open the window. The screen appears similar to Figure 69 below.
Figure 69: Edit User Table Window
b. Use the four arrow keys to move to the desired entry in the table.
c. Press [ENTER] . Then use the numeric keys to enter the desired data, which appears in the right corner of the
window above the table.
d. Press [ENTER] to confirm the data, which then appears in the appropriate cell in the table.
e. Repeat steps b, c and d until you have completed entering data for the table.
f. When you have finished, press [F3] (OK) to confirm the entries or [F2] (Cancel) to leave the window without
confirming the table.
The program returns to the User Functions Tables window.
• To confirm the entries and return to Operate Mode, press [F3] (OK). The CTF878 returns to Operate Mode.
• To leave the window without confirming the entries, press [F2] (Cancel) or the [ESC] key. The CTF878 returns to
Operate Mode.
OK Cancel
UserTable1 Y
5
4
3
2
1
Edit User Table 1