Baker Panametrics CTF878, Руководство по программированию, Страница: 13 / 88

Model CTF878 Programming Manual 7
Chapter 1. Programming Site Data
Figure 7: Transducer Selection Warning Screen
The Receiver Board option number corresponds to the frequency range selected with the original order (see Table 3
below).
4. Compare the Receiver Board option number listed on the WARNING screen with the one assigned to your CTF878.
Note: The Receiver Board option number is the last digit of the CTF878’s model number. That model number can
be found on the label attached to the inside of the front cover. In
Figure 8 below the Receiver Board option number is
3
.
Figure 8: Transducer Type Options
The program now varies, depending on whether you have selected typical or special transducers.
• If you have selected a typical transducer, the CTF878 comes programmed with the needed parameters.
Proceed to Parameters for Typical Transducers below.
• However, if your application requires entering a special transducer / receiver option, go to the next section,
Parameters for Special Transducers on page 8.
1.5.1.1 Parameters for Typical Transducers
If a typical transducer has been selected, the user must:
1. Enter the transducer wedge temperature (Wedge Temp) text box and press [
ENTER
].
2. Type in the value (provided by the factory) and press [
ENTER
].
3. Proceed to Entry Confirmation on page 8.
Table 3: Frequency Options
Option No. Frequency Range
3 1 MHz / 888 KHz
4 500 KHz / 471 KHz
5 250 KHz / 222 KHz
T
z
OK
This transducer selection requires
a matching Option 3 (1000/888
kHz) Receiver Board. See manual
for details.
Transducer/Pipe
* * * WARNING * * *