Baker Hughes Panametrics AquaTrans AT600, Руководство пользователя

Страница: 69 / 174

AquaTrans™ AT600 User’s manual 59
Chapter 4. Initial setup and programming
4.7.4 Programming the pipe menu when clamp-on selected
4.7.4.1 Setting the pipe OD, ID, and wall thickness
Note:
The units shown are the units selected in the units setting menu.
IMPORTANT: Changing the pipe ID (inside diameter) automatically changes the wall thickness. Similarly, changing the
wall thickness automatically changes the pipe ID.
4.7.4.2 Selecting the pipe material
Note: Table 3 below lists the available pre-programmed pipe materials.
Select pipe and press [√]. The following
screen opens.
In the sensor setup menu, select pipe
OD, pipe ID or wall thickness and press
[√]. A screen similar to the following
opens.
Press [√] again, and a screen similar to
the following opens.
Use the [

] or [

] key to select a specific digit, then use the [

]
or [

] key to change that digit as required. After all digits are
correct, press [√] to save. Then, press [x] to return to the
previous screen. Repeat these steps to enter the pipe ID and
wall thickness. Then, press [x] to return to the pipe menu.
In the pipe menu, select pipe material and
press [√]. The following screen opens.