Baker Hughes Panametrics AquaTrans AT600, Руководство пользователя

Страница: 55 / 174

AquaTrans™ AT600 User’s manual 45
Chapter 4. Initial setup and programming
4.6.2.2 Setting the pulse output
Setting the measurement type
Setting the pulse value
Note:
The units shown are the units selected in the units setting menu.
The pulse output generates a square
wave pulse for each unit of flow that
passes through the pipeline. Select
pulse and press [√] to open the
following screen.
Select measurement and press [√] to
open the following screen.
In the measurement menu, select the
type of analog output to be used, and
press [√] to return to the previous
screen.
Use the [

] or [

] arrow keys to select pulse
value and press [√]. A screen similar to the
following opens.
The pulse value is the amount of flow
represented by one pulse in the display.
(e.g., 1 pulse = 10 m^3.) To change the
existing setting, press [√] and a screen
similar to the following opens.
Use the [

] or [

] key to select a specific
digit, then use the [

] or [

] key to change
that digit as required. After all digits are
correct, press [√] to save. Then, press [x] to
return to the previous screen.