Baker Hughes Masoneilan SVI3, Инструкция по эксплуатации

Страница: 56 / 123

56 | Baker Hughes.
© 2021 Baker Hughes Company. All rights reserved.
4. Press * to run the calibration and press Smart Cal/Back to cancel.
5. When Calibration runs, it should indicate the status.
6. When Calibration completes, tuneOK should appear.
4.3.6 NORMAL Operating Mode and MANUAL Mode Menus
When you leave the NORMAL mode to go to MANUAL mode the valve is placed in the last
position it was in when leaving NORMAL . When in the MANUAL mode the device does not
respond to the 4 - 20 mA signal. However , the SVI3 unit can still respond to HART
®
commands, including HART
®
commands to position the valve . When you switch to the
VIEW DATA or VIEW ERR menus from the NORMAL operate mode menu, the valve is still
in NORMAL mode and still responds to the 4 - 20 mA signal.
Figure 31 NORMAL Operation and MANUAL Menu Structures
Normal Mode
Main Screen
NORMAL MANUAL
VIEW
DATA
VIEW ERR CLR ERR
MANUAL Mode
Main Screen
VIEW
DATA
Menu
VIEW
ERRors
Menu
Clear Errors
NORMAL MANUAL
VIEW
DATA
VIEW ERR CLR ERR
MANUAL
SETUP
MAN POS
<value>
<value>
* - +
CONFIG
CONFIG CALIB
*
+
+
+
+
+ +
+
+
+
+
*
*
*
*
*
*
*
*
* *
any key
+
+
+
+ +
+
* * * *
Pressing any display key
*
CALIB
Menu Menu
while in Main Screen moves to
top level Main Menu
*
Press the Back up
button at anytime
to cancel the
selected action
and return to the
menu item above
it in the navigation
tree.
In Manual Mode, the
Top Level main menu
will be different and
will have additional
configuration options
Refer Section 4.3.4
VIEW DATA Menu Refer Section 4.3.5
VIEW ERR Diagnostic
Messages
CLR ERR
VIEW
DATA
VIEW
DATA
MENU VIEW
ERRors
Menu
+
+
*
*
VIEW ERR
Clear Errors
*
*
+