Baker Hughes Masoneilan SVI3, Инструкция по эксплуатации, Страница: 23 / 123

Masoneilan SVI3 Installation and Maintenance Manual = | 23
© 2021 Baker Hughes Company. All rights reserved.
3.2 Pre-Installation Guidelines
3.3 Installation Steps
Exercise care when unpacking the control valve and its mounted accessories.
If you experience problems that are not documented in this guide call the factory or your
local representative. Sales offices are listed on the last page of this document.
Compliance voltage testing is best done before installation. See 7.5 “Determining an SVI
Positioner Compliance Voltage in a Control System” on page 111.
The steps necessary to complete the SVI3 installation and software setup are outlined in
Table 1.
NOTE : Prior to beginning the installation process review the “Safety Information and
Documentation Standards” on page 7.
Table 1: SVI3 Installation Steps
Procedure Reference
Attach mounting bracket to the actuator. See 3.4.2 “Mounting the SVI3 on Rotary Valves” on
page 25 and 3.4.4 “Mounting the SVI3 on
Reciprocating Valves” on page 30 for instructions
Install the SVI3 magnetic assembly (rotary
valves only).
See 3.4.2 “Mounting the SVI3 on Rotary Valves” on
page 25 for instructions
Assemble the SVI3 on the bracket that is
mounted to the valve actuator.
See3.4.2 “Mounting the SVI3 on Rotary Valves” on
page 25 and 3.4.4 “Mounting the SVI3 on
Reciprocating Valves” on page 30 for instructions.
Connect the pneumatic tubing and air
supply to the SVI3. Natural gas installation
considerations (optional).
See “Connecting the Tubing and Air Supply” on
page 34 for instructions.
Wiring the SVI3. See 3.6 “Wiring the SVI3” on page 36 for instructions.
Configure/Calibrate using LCD Pushbutton
display
See 4.3 “Local Interfaces and Configurations” on
page 52, 4.3.5 “Perform Smart Cal” on page 55 and 4
“Tap Fault List to view the full fault code list.” on
page 71 for instructions.
Configure/Calibrate using SVI3 DTM with
Valvue3/AMS
See 4.2 “Configuring and Calibrating with SVI3 DTM
with Valvue” on page 52 for instructions
Configure/Calibrate using a SVI3 DD files in
HART
®
Communicator/AMS.
See 4.3 “Local Interfaces and Configurations” on
page 52 for instructions