2.4 System Components Required
To install, configure, and use the Ranger Pro Ranger Pro wireless sensor, you need:
l
Lithium-thionyl chloride batteries, one per device. For approved battery types, see the
Ranger Pro - Warning, Special Conditions and Additional Information
(document
126M6550).
l
Battery installation tool.
l
Ranger Pro, either or both tri-axial and uniaxial devices, with batteries installed.
l
(Optional) Ranger Pro repeaters with batteries installed.
l
Mounting hardware (plus adapters, if needed).
l
A compatible USB NFC reader. Contact
Bently Nevada technical support
for a list of
compatible readers.
l
Ranger Pro Configuration Software (121M7997, available from
).
l
Spot facing tool, if required. (Not provided by Bently Nevada.)
l
Torque wrench with ¼ inch drive, capable of tightening devices in the 5-7 Nm
(44 to 62 in lb) range. (Not provided by Bently Nevada.)
An Installation Kit (130M5452) is also available. The installation kit can be ordered with or without
the USB NFC reader. For ordering information, see the
Ranger Pro Datasheet
(document
125M5237).
9/56
Ranger Pro Wireless Condition Monitoring Device
User Guide
125M6113 Rev. D
