To unprovision a single device using the Ranger Pro Configuration Software and a NFC reader:
1. Connect the NFC reader to the computer running the Ranger Pro software.
2. Open the Ranger Pro Configuration Software.
3. Select the
NFC Manager
tab.
4. Connect the USB NFC reader to the PC running the configuration software. If necessary,
install any drivers required. To obtain drivers, visit the website of the USB NFC reader vendor.
5. Select the appropriate USB NFC reader in the
NFC Manager
tab header.
6. Place the Ranger Pro device upside down on the USB NFC reader pad.
7. Verify that the NFC status in the footer is
Ready
.
8. Select the
Configuration Manager
>
Live Configuration
tab and click on the Unprovision
button.
9. Click
Unprovision
. Before removing the device from the NFC reader, wait 10 seconds.
Upon completing these steps for ISA100 devices, the Ranger Pro device is unprovisioned,
disconnects from the network, and is ready to be provisioned for the same or a new ISA100
network.
Although not required when changing networks, WirelessHART devices can be unprovisioned
using a USB NFC reader to place the device into a deep sleep state.
4.5 Reboot the Device
If after several hours the device fails to join the network, reboot the device. Remove the device
from the field and reboot the device in an equipment room or similar environment.
To reboot a single device:
1. Open the Ranger Pro Configuration Software.
2. Connect the USB NFC reader to the computer running the Ranger Pro software.
3. Place the Ranger Pro device upside down on the NFC reader pad.
4. Select
NFC Manager
tab.
5. Verify that the NFC status is
Ready
.
6. Verify that the Ranger Pro device status is
Ready
.
7. Expand
Sensor Maintenance > Power Control
.
8. Click
Reboot
. The device is restarted.
28/56
Ranger Pro Wireless Condition Monitoring Device
User Guide
125M6113 Rev. D
