BAK PLANON, Руководство по эксплуатации

Страница: 9 / 20

BAK Thermoplastic Welding Technology AG
9
1.7. Insert the new heating element - observe marking, voltage and power rating
1.8. Slide on the mica tube
1.9. Slide on the gasket and position the boreholes
1.10. Slide on the nozzle and fix with 4 screws
1.11. Readjust the nozzle as described under basic adjustments.
2.0
Adjustment of the welding seam width to 20/30/40mm (see page )
3.0 Mounting of the hem kit (see page )
4.0 Mounting of the keder accessories/kit (see page )
5.0 Mounting of the guide handle (see page
ACCESSORIES
Available accessories:
Change of the welding seam width 20/30/40mm (5230155/5230156/5230157); Hem kit
(5230109); Keder kit 20/30/40mm (5230189/5230192/5230193); Guide handle (5230077).
The automatic welding machines can either be supplied with the accessories directly
assembled or the assembly can be easily carried out by the operator himself.
Optimum results will be achieved when BAK- accessories and spare parts are used.
Please refer to our brochures for additional information.
MAINTENANCE
Clean the welding nozzle with a wire brush (5201330).
Check if the mains cable and the plug are not electrically or mechanically damaged.
TRANSPORT – HANDLING – STORAGE
Transport:
The welding machine is packed appropriately and must be protected from moisture.
Handling:
The shipment must be checked for completeness and transport damage. In the event of
transport damage, the defect must be confirmed in writing at the time of the delivery by the
carrier. The seller must be promptly informed in writing!
Storage:
In the case of temporary storage, the welding machine should be kept packed and must be
protected from moisture. In the case of damage resulting from improper storage, no warranty
claim will be honoured.
WARRANTY AND LIABILITY
Warranty and liability apply from the date of purchase (documented by the invoice/delivery
note) according to the currently valid general terms of business of BAK. BAK refuses to
honour any warranty for devices which are not in their original condition. BAK devices may
never be reconfigured and/or modified.
BAK reserves the right to deny any responsibility if this is ignored. No liability can be
assumed by BAK for incorrect installation and/or use as well as natural wear and tear of
components (e. g. heating elements).