All Right Reserved © SHENZHEN BAK POWER BATTERY CO., LTD
13
Integrated Lithium-ion Battery Pack
User Manual
2 ILLUSTRATION
Press RST key for 3 seconds to start the device, or press the RST key for 3 seconds
again to shut down the device. When the system is running, should there be an
exception (alarm), press this button for 6 seconds to reset the system (press /
release) to ensure the stability of the system.
Dry contact
Not used. (For special applications it can be factory wired/programmed to customer
requirements such as: To provide an interface for remote monitoring of the battery.
Failure Alarm: Indicate BMS or battery faults including but not limited to charge and
discharge MOS fail, cell voltage under 0.5V, NTC disconnect.
Protection Alarm: Output short circuit, charge and discharge over current, charge and
discharge over temperature/low temperature.
Output
A terminal of 4 connections, 2 for positive, 2 for negative, each connection is for a
M6 ring-lug.
LCD display
（
optional
）
LCD display can read Battery status, cell status, firmware version, protection/alarm,
etc.
2.2
Menu operation instructions
（
optional
）
The LCD display interface is user-friendly, as shown in figure 2-5. It provides 320 *
240 dot matrix graphic display. The LCD is able to display the alarm information in
real time, and provides the historical warning records for the user to query, and
provide a reliable basis for fault diagnosis.
Users can easily browse the battery parameters through the LCD interface, and
obtain timely access to information on the current state of the battery. The interface
displays a total of 5 menu keys, the functions described as follows.
Figure2-5 LCD Display
