20
1. Remove oil drain Plug, located at bottom of engine and let oil drain into
an approved collection container. DO NOT PERFORM THIS PROCEDURE
WHILE ENGINE IS HOT. SERIOUS BURNS COULD RESULT FROM
CONTACT WITH HOT OIL.
2. Dispose of the used oil properly. For proper disposal procedures,
contact your local oil recycling center.
3. Remove oil filter plug and screen, Clean oil filter screen with solvent.
4. Re-install oil Plug.
5. Re-install oil filter screen and screen plug
4. Refill engine with proper amount of oil and recheck amount of oil by
using dip stick and/or sight gauge.
CHECK-UP OF SPARK PLUG
1. Remove the cap of spark plug and screw off
the spark plug using the plug wrench.
2. Clean the spark plug all around or replace it
if it is corroded or there is too much deposit
on it.
3. Regulate the gap of the spark plug to 0.6-
0.8mm.
.024” - .032”
3. The spark plug of the designated type
should be used. The applicable type of
spark plug: D8EA (NGK)
0.6~0.8mm
(.024” - .032”)
CHANGING ENGINE OIL AND CLEANING SCREEN
Screen Plug
Oil filter screen
Spring
Oil Plug
MAINTENANCE
