TradiePack - User Guide v1.3
Installation & User Guide
TP Range
5
Avoid direct sunlight
–
the internal temperature of the enclosure can rise quickly due radiation from
the sun.
Operating outside of these guidelines diminishes the life and performance of the battery and voids
the warranty.
Avoid repeated shock and vibration
Whilst the battery is robustly constructed and protected in an aluminium enclosure, it is not designed
to operate continuously in high shock or high vibration environments. Normal use in a 4WD
environment is acceptable and the battery has been designed in accordance with these expected
conditions. However, dropping the battery or exposing the battery to a high number of excessive
vibrations may lead to a fault or failure of the battery.
Avoid exposure to water or salt spray
Whilst the battery is mechanically protected, the enclosure is only IP20 equivalent and is not designed
for a wet environment. Do not submerge the battery in water or expose the battery to direct water
spray.
Avoid exposing the battery long term to salty water spray such as in a marine environment to avoid
corrosion. Salt laden air may also cause corrosion in the long term; therefore, minimise exposure by
installing the battery in a protected hatch or compartment.
Do not short circuit the battery
Always perform work on passive wiring first and connect the live battery as the last connection. If you
have to work on live circuits exercise due care and use insulated tools where possible. If you are unsure
how to install the battery, seek advice from Baintech or a suitably qualified electrical tradesperson.
Check to ensure the connecting Anderson plugs are correctly wired (positive and negative) and do not
attempt to mismatch Anderson colours when connecting.