INSTALLATION
SETUP/PHYSICAL INSTALLATION
I-E96-419A
2 - 5
Figures
and
show the cable connections. To install the
cables:
NOTES:
1.
Properly mount the TTA termination unit on the field termination
panel
before installing the cables.
2.
If a module is installed, pull it several inches from the backplane
before inserting the cable into the module mounting unit backplane.
1. Insert the hooded end of a KTU cable into the module
mounting unit backplane slot assigned to the IMAMM03 mod-
ule. The cable should latch securely in place. Card edge con-
nector P3 of the IMAMM03 module connects to this end of the
cable.
2. Insert the male 36-pin connector end of the KTU cable from
the IMAMM03 module into the P2 connector of the first (or
only) TTA termination unit. The cable should latch securely in
place.
Figure 2-3. Termination Unit Mounting Diagram
CHASSIS COMMON
SCREW
TABS
STANDOFF
MOUNTING SCREWS
FIELD TERMINATION PANEL
T00592A
