INSTALLATION
INSTALLING THE MODULE
3 - 10
I-E96-221A
®
2. Verify connection of the other end of the cable to the first
column of two tabs on the lower left of the next MMU back-
plane.
NOTE: Because of high-speed transaction constraints, install a
maximum of eight related (Controlways linked by cable) MMU back-
planes within one cabinet. Do not cable link Controlways in separate
cabinets. Connecting three-wire lengths between MMU backplanes
should be minimized to prevent crosstalk and interference.
INSTALLING THE MODULE
NOTE: Before installing the IMCPM02 module, check the MMU
backplane for -30 VDC. If the system uses an NAMM01, NAMM02,
NLMM01, NCOM01 or NCOM02 module, then -30 VDC is required.
Set J12 for before installing the IMCPM02 module into the system.
1. Face the rear of the cabinet. Locate the -30 VDC faston. It
is the second faston from the top of the MMU backplane.
2. Check for -30 VDC with respect to system common at the
-30 VDC faston. The -30 VDC is not connected in INFI 90 sys-
tems.
Figure 3-7. Controlway Cable Installation
T00063A
