Bailey C-I-CV42C, Инструкция, Страница: 115 / 214

PR8 - 2 WBPEEUI220771A0
Procedure
□
3. Place the module in the proper rails.
□
4. Push gently on the module until the edge connector on the
module is firmly seated in the connector on the backplane.
□
5. Press on the tabs at the side of the module to secure it in
the multibus card cage.
□
6. Connect the appropriate cables to the module.
□
7. Slide the card retainers toward the center of the multibus
card cage until they are stopped by the screws.
□
8. Use the bladed screwdriver to tighten the screws on each of
the card retainers.
□
9. Install the clear polycarbonate shield onto the front of the
multibus card cage.
All Other Models
□
1. Verify that the main power switch is in the off position.
Check the main power indicator to see if power is removed.
□
2. The IIMKM02A module has four retaining screws. Use the
bladed screwdriver to install the screws.
□
3. Install all cables onto the IIMKM02A module.
Figure PR8-1. Module Location
T01446A
IIMKM02A
W1