Baileigh SS-2421-V2, Руководство оператора

Страница: 14 / 64

11
11
CUTTER SELECTION. Use only those cutters designed to be used on the machine, and mount
only safety type cutters on the spindle.
STOCK CONDITION. The danger of kicked back stock can occur when the stock has knots,
holes, or foreign objects such as nails. Warped or in
– wind stock should first be jointed on one
surface before attempting to use it on the shaper.
JOB COMPLETION. The operator should never leave
the work station for any reason without turning off the
shaper and waiting for the spindle to come to a
complete stop. When the operation is complete, the
operator should clean up the shaper and work area.
Never clean the shaper with the power “ON” and
never use the hands to clear sawdust and debris
–
use a brush.
DO NOT REACH over shaper. There is danger of
kickback which can pull the hand back into the cutter.
Use push sticks to assist in pushing the work through.
See Figure 4.
A push block and/or a push stick must be used if the
workpieces is less than 5” (127mm) to prevent your
hands from getting too close to the saw blade. Push
block must be used to cut narrow workpieces and, when
necessary, to push the workpiece against the
fence, a push block can be easily made by the
operator.
INTENDED USE

Purpose of the machine
The machine enables semi-finished products
made of wood or materials based on wood to
be milled with a vertical spindle.
The machine is designed for operation performed by one worker only.
The machine may not be handled by children in any manner.

Workers’ qualifications
Only an expert skilled in the field of wood-machining or a worker instructed and trained by
such an expert may operate this machine.
While working on the machine the operator must get familiar with these instructions and
comply with any safety rules, regulations and provisions in force in the respective country.