Baileigh IP-2011-HD, Руководство оператора

Страница: 22 / 48

19
19
POWER CONTROLS
There is a LED readouts on the digital control. The LED shows the actual position of the table.
Table Movement - Manual
1. Press the or button on digital control.
2. Table movement will stop when the button is released.
Table Movement - Programmed
1. Press the PROGRAM key, LED will blink. KEY indicator turns on.
2. Using the numerical keypad, enter the target value for the table position.
3. Press the START key, RUN indicator turns on, table moves to target height.
Note : To cancel the table movement before it has reached the target value, press
the STOP key. To restart the procedure, you will have to reenter the target value again.
Reset Digital Control to Actual Thickness
If the thickness number showing on LED readout is different from actual stock thickness, digital
control need to be reset.
1. Measure the actual height from blade BDC to table surface. This can be done by measuring
a stock which has just been cut and the height has not been changed.
Note : To be entered properly. This dimension MUST be in millimeters.
2. Press the PROGRAM key LED will blink.
3. Enter code 56789.
4. Press the PROGRAM key again.
5. PRESS the 0 key several times, to change all the numbers on LED to 0.
6. ENTER the actual thickness data according to the stock thickness that is measured.
7. Press the PROGRAM key to save the dimension.