Baileigh HSP-60M-C, Руководство оператора, Страница: 32 / 48

29
29
Table Adjustment
Lifting the table is performed using the lifting chain
attached from the ram to the table.
1. If lifting the table; start with the piston extended to
full stroke. If lowering the table; start with the piston
extended about
1” (25mm).
2. Loosen the piston head enough to allow the lift
chain clevis to slip between the head and the ram.
Snug to head to the clevis to hold it in position.
3. Place the links of the lifting chains in the slots of
the table lift links. Remove as much slack form the
chains as possible.
4. Raise the piston enough to lift the table to remove
the table support pins.
5. Lower or raise the table high enough to align the
support holes of the table and the frame and then
install the support pins.
Note: The table always needs to be
higher than the hole you want to place the support pin.
It may be necessary to reach the desired table
position in more than one step.
6. The support pin is installed correctly when the
collar is tight to the table and the table slot rests
fully on the pin.
7. Lower the table until it rests on the support pin(s).
8. Remove the lifting chain out of the working area.
IMPORTANT:
NEVER lift or lower the table with tooling or material or
pressure from the ram on the table. This will damage the machine voiding the
warranty.