22
22
Cutting Operation Cycle
•
Set the miter cut angle
•
Open the vise jaws.
•
Load and clamp the piece part.
•
Adjust the bar stop for cutting length.
•
Check that the main power disconnect switch (
V
) is on.
•
Grasp the feed handle (
H
).
•
Press the trigger switch (
G
) to start blade motor.
•
Pull down the feed handle (
H
) applying a steady and constant
pressure.
•
After cut-off, raise feed handle slowly.
•
Release the trigger switch (
G
) to stop the blade motor.
•
Use vise hand wheel to open the jaws.
•
Remove or advance the piece part forward for next cut.
•
To turn off machine power, turn the main power switch (
V
) to
off.
•
To stop machine in an emergency situation press the
EMERGENCY STOP
button (
P
).
•
Before machine can be restarted, emergency stop button
must be reset with a clockwise (
cw
) twist.
V
H
G
P
Содержание AS-350M
