17
17
OPERATION
Machine Start-up
Operation of this machine is very straight forward. Follow the next steps to become familiar with
the machine.
1. Plug in the machine to a properly grounded 115V outlet.
2. Select the Forward or Reverse operation (A).
3. Select which control you would like to use “Foot
Control” or “Panel Control” (B).
a. If you select “Panel Control” the chuck will
begin to rotate in the direction chosen and
the speed the “Speed Pot” (C) is set at and
the foot control will be de-activated.
b. If you select “Foot Control” the foot pedal
will start and stop the chuck rotation and
control the speed up to the speed in which
the “Speed Pot” on the control panel is set
to.
4. When the chuck and any material installed
into/onto the chuck is clear of any persons or
objects, Turn the power switch (D) to ON.
a. If Panel Control is selected, the chuck will
rotate at the selected speed.
b. If Foot Control is selected, the chuck will not
rotate until the foot pedal is depressed.
It is best to practice welding on a piece to set the optimum chuck speed.
Clamp the material into/onto the chuck tight enough to hold the material so that it will not spin or
slip or be deformed.
CAUTION:
Always wear proper eye protection with side shields, safety
footwear, and leather gloves to protect from burrs and sharp edges.
When handling large heavy material, make sure they are properly supported.
A
B
C
D
Содержание WP-1800B
