Baileigh Industrial IP-2209-HD, Руководство оператора

Страница: 32 / 60

29
29
OUT-FEED ROLLERS ADJUSTMENT
The out-feed rollers should be set 0.02” below the lowest point of knife. Make sure the knives
are set properly. See the “Setting / Changing Knives” section prior to making any adjustments.
1. Disconnect machine from power source.
2. Place a hard wood gauge (A, Fig 13) under a
knife in the cutterhead.
3. Place a 0.02” feeler gauge (B, Fig 13) on top of
wood block and raise table until the gauge
contacts the knife in its lowest position.
4. Remove feeler gauge and place wood block (E,
Fig 19) under the left side of out-feed roller (F,
Fig 19).
5. The top of wood gauge should just contact the
out-feed roller.
6. If it doesn’t, loosen jam nut (G, Fig 17) and turn
the adjusting screw (H, Fig 17) to raise, or
lower the out-feed roller until it contacts wood
gauge.
7. Repeat for opposite side of the out-feed roller.
8. Repeat for second out-feed roller.