Baileigh Industrial IP-2209-HD, Руководство оператора

Страница: 22 / 60

19
19
TABLE ROLLER HANDLE ASSEMBLY
Thread the handle (C, Fig. 4) into the hub.
HANDWHEEL ASSEMBLY
Line up the key on handwheel shaft with the key
way in the handwheel. Slide the handwheel (D,
Fig. 4) into place and secure with knob (E, Fig. 4).
CONTROL PANEL
Emergency Stop Button (F): Stops all functions of
machine, but the planer still has power. To reset
rotate switch clockwise until the button pops out.
Main Motor (G): Starts rotation of cutterhead.
Will not work if the "Emergency Stop" switch is
engaged, or hood is open.
CHANGING FEED RATE
The planer has two selectable feed speeds that
feed stock at 20 and 30 feet per minute (6-9mpm).
To adjust speed, move lever (H, Fig. 5) until it
clicks into place.
Important: Change feed speed only
while the feed system is RUNNING!
TABLE ROLLER ADJUSTMENT
Loosen the handle (I, Fig. 4) and move the table rollers up, or down by raising, or lowering the
handle (C, Fig. 4). When you reach the desired position tighten the handle.
The rollers are usually set higher when planing rough stock. When planing smooth stock the
table rollers should be set only slightly above, or flush with the table.