Baileigh Industrial DP-1850G, Руководство оператора

Страница: 17 / 52

14
14
Oil Filling
The gear box incorporates an oil pump to lubricate the gears.
The machine is supplied without oil for transport reasons.
1. Remove upper plug.
2. Using a funnel, add oil until the oil level is between
the red mark (center) and the top of the sight glass.
Approximately 2.6qt. (2.5L) of ISO 40 to ISO 46
circulating oil.
3. Install the fill plug.
4. When assembly is complete, and the spindle is
clear, start and run the spindle for several minutes
to circulate the oil.
5. Stop the spindle and check the oil level.
6. Add oil as needed to bring the level up to the
center red mark in the sight glass.
ASSEMBLY AND SET UP
1. Clean the rust protective coating off of the bare
metal surfaces.
Important: This waxy coating is NOT a
lubricant and will cause the machine to stick and lose
performance as the coating continues to dry.
2. Remove and retain the four cap screws and lock
washers from the top of the drill head.
3. Remove and discard the wax paper covering the
gear opening.
WARNING:
For your own safety, DO NOT connect the machine to the
power source until the machine is completely assembled and you read and
understand the entire instruction manual.
A
B