Baileigh Industrial DP-1400VS, Руководство оператора

Страница: 22 / 48

19
19
Drill Chuck Install
The drill chuck attaches to the spindle by
means of the arbor. Matched tapers on the
arbor and the inside of the chuck create a
semi-permanent assembly when properly
joined.
To assemble the drill chuck and mount it to the spindle:
1. Use mineral spirits to thoroughly clean the drill chuck,
arbor, and spindle sockets and dry all surfaces before
assembly. Failure to clean the mating surfaces may cause
the tapered fit to loosen during operation, resulting in
separation and an unsafe condition.
2. Use the chuck key to adjust the jaws of the drill chuck until
they are fully retracted inside the drill chuck body.
3. Place the drill chuck face down on a workbench. The arbor
has a short taper and a long taper. Place the short taper
into the socket in the back of the drill chuck and tap it with
a rubber or wooden mallet. If the chuck fails to remain
secure on the arbor, repeat Steps 1 & 2.
4. Slide the arbor into the spindle socket while slowly rotating
the drill chuck. The socket has a rectangular pocket where
the tang, or flat portion of the arbor, fits into.
5. Seat the chuck with a rubber mallet.
Arbor
Chuck Key
Drift Key
Drill Chuck