Baileigh Industrial CS-350EU, Руководство оператора

Страница: 36 / 60

33
33
MACHINE ADJUSTMENTS
Adjusting the Mitering Lock Lever
1. The lock lever may require adjustment when the lever contacts
the machine base and fails to lock the machine head at required
angle. To re-adjust lever:
2. Loosen bolt (A).
3. Support the bushing (B) so that it does not drop.
4. Pivot lever (C) to unlock side (D) to allow more range of motion.
5. Re-tighten bolt (A).
Adjustment of Saw Blade Head
If excessive axial play is found on the pivot hinge, it will be necessary to tighten the screws.
NOTE: Do not overtighten.
To adjust the saw blade head:
•
Loosen the 3 set screws on each hinge nut (A).
•
Tighten the nut to remove the axial play without causing
the pivot to bind.
•
Tighten the 3 set screws on each hinge nut (A).
Setting Saw Blade Head Stop
To adjust the saw blade head stop:
•
Loosen the jam nut (B).
•
Turn the stop bolt up or down as desired to set the stop
position of the blade. DO NOT allow the blade to be
lowered to contact the vise (C).
•
Hold the stop bolt in position and tighten the jam nut.
WARNING:
BEFORE PERFORMING THE FOLLOWING OPERATIONS,
THE ELECTRIC POWER SUPPLY AND THE POWER CABLE MUST BE COMPLETELY
DISCONNECTED.
A
C
B
C
B
A
D