Baileigh Industrial BS-712MS, Руководство оператора

Страница: 40 / 60

37
37
Changing Blade Speed
To change speeds from position 1 to 2 to 3.
1. Disconnect power to the saw.
2. Turn the handle on the reducer with one hand and use the
other hand to slide the blade back and forth until the handle
engages the required gear. (Wear proper hand protection.)
a. Speed 1, 125 FPM is used to cut tool steel, stainless
steel, hard cast iron, alloy steel, and hard bronze.
b. Speed 2, 215 FPM is used to cut mild steel, soft cast
iron, medium hard bronze, hard aluminum, and plastics.
c. Speed 3, 270 FPM is used to cut plastics, soft or
medium soft aluminum, wood, and other light
materials.
3. After the speed change, re-connect power to the saw.
Note: There is also a speed selection chart
posted above the gear box.
Vertical Cutting
1. Move the saw bow to the 0°
position.
2. Raise the saw bow to the
vertical position and lock in
place by turning off the
hydraulic cylinder valve.
3. Remove two screws (Z) and
take off deflector plate (AA).
4. Slide the slot in the plate over
the blade and attach the plate
with the two screws removed
in step 2.
CAUTION:
AVOID TIP OVER! The saw bow must be in the 0
°
position
before raising the bow to the vertical position. The Support Bar must be installed
prior to using the saw in the vertical position.
Z
AA