40
40
Y AXIS TEACH IN
The Y axis teach in is used to calibrate the relative position of the Y axis (bending ram) at the
specific time it is being measured. This is not a common adjustment to be performed.
This calibration is done by placing a piece of paper on the top of the die and then lowering the
ram so that the bottom of the punch just touches the paper on the top of the die without bending
the paper.
1. Place a piece of paper across the die.
2. Lower the punch in single stroke mode until the
punch just touches the paper without bending it.
3. Press the Red Stop key on the controller to return
to the programing screen.
4. Pressing the
key to toggle the screen to
the “CONST” programming screens. The
“CONST” screen is a reference screen. DO NOT
make changes on this screen. This is also an
access screen to deeper parameter settings.
5. Key in the access code of 1212 to enter the
“Teach In” screen.
6. Use the down arrow key to move to and highlight
the
“Y-tea. In:” line.
7. Enter the value of 1.000 into the controller and
press enter to set the Teach In value for Y. The
smallest value that may be programmed in for this
setting is 0.118.
8. Once entered, press the
key to return to
the Single screen. The Y axis is calibrated.
Содержание BP-3305CNC
