Baileigh Industrial BP-3305CNC, Руководство оператора

Страница: 25 / 56

22
22
CYCLE MODE SELECTOR SWITCH
–
The Cycle
Mode Selector switch (E) is a 2-position switch which
allows you to pick one of two bend modes.
•
In the lef
t “inch” mode, the die will move down or
up when the foot pedal is pressed and stop when
the foot pedal is released. Inch mode is typically
used during setup and testing.
•
In the right “semi-auto” mode, the ram will continue
to cycle down and up based upon the program
settings in the E21 controller. The ram will start
automatically and pause based on time delay
settings and stop when the total number of piece
parts have been completed. Semi-Auto mode is
typically used to bend parts after setup whether in
Single or Programmed operation.
E-STOP BUTTON
–
When pressed, the red E-STOP
button will stop all machine functions will stop. Turn
button clockwise (
cw) to reset.
E21 CONTROLLER
Keys
Clear/Delete key, clear current numbers
entered.
Enter: In programming interface, press
this key to confirm the parameter entered and switch
between parameters.
Stop, Stops operation and the LED in the corner will illuminate. Press the Stop key
to access the controller programming to change settings.
A B C
D
E
F