Baileigh Industrial BHVBS-712B, Инструкция по эксплуатации и каталог запасных частей

Страница: 9 / 32

9
4. Install handle with flat washers and nut (C,
Figure 6-5), using 19mm wrench. To install,
raise bow to vertical position and open guard.
CAUTION: Spring-tensioned stop bracket (see
Figure 7-1) must be rotated out of the way
before raising bow.
Figure 6-5: Installing Handle
5. Install work stop rod into hole and tighten
knurled knob (A). Slide stop block onto rod and
secure with thumb screw. See Figure 6-6.
Figure 6-6: Installing Work Stop
6. Install the motor and the belt:
a) The motor comes packaged in the carton on
the bottom of the stand.
b) Unpackage the motor and install it onto the
female bracket plate (the female bracket
plate is attached to the bow surface).
c) Push the motor to the end position (Figure 6-
7) this is the preset position before leaving
the factory.
Figure 6-7: Preset Motor Position
d) Tighten the 5/16" hex screw and nut (A,
Figure 6-8).
Figure 6-8: Tighten 5/16” Hex Screw
e) Install the belt (A, Figure 6-9) on the pulley
of the transmission. For speed selection and
belt tensioning, see section 8.3 Blade
Speed.
f) Connect the male/female plug and ensure
that it is always tight (A, Figure 6-9-1).
7. Slide the pulley cover (A, Figure 6-10) over the
spindles and secure with screws and washers
(HP2/HP3), using 10mm wrench.
8. Install the lock screw (HP1) to secure the pulley
cover.
Figure 6-9: Installing Belt
Figure 6-9-1: Plug Connection