Baileigh Industrial BB-9616M, Руководство оператора

Страница: 18 / 40

16
16
Footswitch
1. Unstrap and straighten out the footswitch
cable.
2. Grasp the connector end and plug into
the receptacle at the back of the machine.
3. Tighten the connector sleeve.
Removing and Installing the Bending Extension Bar
Note: For mild steel, 16ga., extension
OFF. 18ga. extension On or Off, 20ga. and thinner,
extension On.
1. Use a marker to mark the top surface of the
extension bar.
2. Remove and retain the mounting bolts (A) and
remove the extension bar and store with the
clamping bars.
3. When installing the extension bar, verify that the
bar and the seat on the bending leaf are clean (B)
and that no metal chips or dirt will prevent the bar
from setting fully into the bending leaf seat.
4. Install the mounting bolts (A) loosely.
5. Verify that the top of the extension bar is flush with
the top surface of the bending leaf and tighten the
mounting bolts keeping the surfaces flush.
figure 5
A
B