18
Figure 3-9: RF Antenna Connectors
3.4.3
Connect Ethernet Cable
Connect the Ethernet cable to the ETH0 interface on the eNB (Figure 3-10), and fasten the
screw. The blue cable in Figure 3-11 in section 3.4.4 shows the Ethernet cable connected.
Figure 3-10: Connect Ethernet Cable
3.4.4
Connect Power Connector
Connect the 48V DC power connector to the PWR interface on the eNB (Figure 3-11, red cable).
Figure 3-11: Connect Power Cable
3.4.5
Connect Grounding Cable
The grounding terminals are the 2 screws beside the antenna feeder interface, as shown in
Figure 3-12. One end of the ground wire connects to the grounding terminal on the eNB. The
other end connects to the outdoor ground point. The connection needs to be tin-soldered.
Refer to grounding guidelines in
