Badger Meter ModMAG M1000, Инструкция по установке и эксплуатации, Страница: 18 / 52

Programming Page 16/47
MID_M1000_BA_02_1802
5. Programming
Programming is accomplished by using the three functional buttons ▲ , ► and Exit/Save .
You can move from the measuring mode to the programming mode by pressing once the
button Exit/Save .
Meter Setup
Main Menu
With the ▲ button you move downwards in the list. With the ► or Exit/Save button you enter
the menu or you move to the next submenu. The scrollbar on the upper right shows at what
position you are in the list. Go back from a submenu to the upper menu press Exit/Save.
To select parameters or values from a list in a menu point, press key ▲ until the requested
parameter or value is displayed and confirm with key Exit/Save . The current number in the
list is marked by a ▪ on the left side. For example ▪DN 50.
To change a parameter enter the menu by pressing the button ► and the first character
flashes. Press the key ▲ to change the figure. Once you have changed the desired figure,
move to the next figure with the key ►. Confirm the new value with key Exit/Save .
*Meaning of symbols on the display
You get access to the individual menus through three programmable access levels:
Administrator, service and user level.
Access rights of the individual menu items are shown in the following with three symbols:
Administrator Service User
For programming the access levels, see the chapter “passwords”.
No passwords were set at the factory.
Minor battery power (Real Time Clock)
Empty pipe detection
Device error
No keyword active
S
Simulation active
USB active
menu header
scrollbar
indication of a submenu
submenu