Badger Meter Blancett B2900, Руководство пользователя

Страница: 38 / 52

Programming
Page 38 May 2020 DSY-PM-01378-EN-08
Reset Password
The reset password parameter restricts resetting the totals on the monitor� The Password
must also be set to restrict the total reset� Initially, the password is set to all zeros and any
user can reset the stored totals on the monitor� To change the password, press
ENTER at
the RstPswd prompt� The first digit flashes� Press
UP
to increment the digit and
RIGHT
to
advance to the next digit� After entering all digits, press ENTER to store the password
and return to the Fluid parameter� The reset password is now required to reset the totals on
the monitor�
OTE:
N
Entering a password in the Passwd screen and leaving the password blank in the
RstPswd screen allows for total resets (not requiring a password), but restricts
programming modification�
Gas
Operating Pressure
At the Op Pres prompt, press ENTER � The first digit of the current pressure setting flashes� If
the current selection is correct, press
ENTER
to advance to the next parameter� To change
the operating pressure, press UP to increment the digit until it matches the first digit of the
correct pressure value� Press
RIGHT
to move to the next digit� When all the digits have been
entered, press ENTER to advance to the Op Temp parameter�
Operating Temperature
At the Op Temp prompt, press ENTER � The first digit of the current temperature setting
flashes� If the current selection is correct, press
ENTER
to advance to the next parameter�
To change the operating temperature, press UP to increment the digit until it matches the
first digit of the correct pressure value� Press
RIGHT
to move to the next digit� When all the
digits have been entered, press ENTER to advance to the next parameter�
In Programming mode the monitor advances to the PulsOut parameter, see “Totalizer Pulse
Output*” on page 30 �
In Extended Programming mode, the monitor advances to the Damping parameter, see
“Damping Factor” on page 29 �
Save Settings and Return to Run Mode
After entering all parameters, press MENU � Saving displays on the menu, followed by
a blank screen and then the firmware version number� The monitor then returns to
Run mode�
IMPORTANT
Settings are not saved until after manually saving with the
MENU
button.