INTOODUCTION
The B2800XP flow monitor is a state-of-the-art digital signal processing flow monitor designed to provide the user with
exceptional flexibility at a very affordable price Though designed for use with Blancett flow meters, this display can be used
with almost any flow meter producing a low amplitude AC output or contact closure signals
The B2800XP flow monitor is capable of accepting a low level frequency input for calculating flow rate and total These
calculations can then be displayed in the desired units of measurement The monitor’s large eight digit by 0 50 inch (12 7
mm) numeric liquid crystal display makes extended range viewing practical The second eight digit by 0 25 inch (6 35 mm)
alphanumeric display provides for selectable units viewing in run mode and prompts for variables in program mode The
display can show rate, total or alternate between both rate and total
Programming
Buttons
MENU
ENTER
EXPLOSION POOOF ENCLOSUOE
The EIH Instrument enclosure is designed to house instrumentation and control equipment as well as act as a conduit outlet
body in hazardous, abusive and wet locations
The EIH enclosure is approved by Underwriters Laboratories Inc , Canadian Standards Association, Factory Mutual and
CENELEC for use in Class I, Groups B*, C** and D; Class II, Groups E, F and G; and Class II hazardous (classified) locations as
defined by the National Electrical Code and Canadian Electrical Code It is also NEMA/UL/CSA Type 4 and IP66 rated for
watertight applications
*With conduit seals installed within 18 inches of enclosure
**Unsealed conduit lengths must not exceed five feet (152 cm)
Introduction
Page 4
March 2017
DSY-PM-00277-EN-03
