Bad Dawg 793-1086-00, Руководство по установке

Страница: 11 / 12

Winch Installation | PAGE 10
EXTERIOR CONTROL SWITCH - OPTIONAL
Step 1
Locate the exterior control switch and the jack plug harness included with the kit (Figure 30).
Step 2
Install the jack plug at the desired location on the UTV. Mounting holes may need to be cut/drilled in order to
fasten the jack to plastic body parts (Figure 31).
Step 3
Route the jack harness to the winch control module and connect the black and green wires to their corresponding
locations, shown in
Figure 24: Switch to Controller Wiring . Connect the red wire to the 12V accessory charger in
the dash. (E) Connect the red wire to the open connector on the winch wiring harness.
Figure 30: External Winch Control Kit
Figure 31: Example Mounting Location