Congratulations and thank you for
purchasing a professional tube ampli-
fi er from Bad Cat. As with all Bad Cat
products, your amplifi er is designed from
the ground up to provide the very best
tones possible in a rugged, reliable pack-
age. Each one of our pro quality models is
constructed with Bad Cat’s commitment
to making the highest quality, hand-built,
American-made amplifi ers.
CAUTION
With a little care and caution, your Bad
Cat amplifi er should provide you with
years of trouble-free operation and
enjoyment. Please avoid damp areas and
moisture during operation of the amp
and in storage. This includes placement
of beverages near or on the amp that
could spill into the amp’s chassis. Liquids
can easily damage tubes, switches and
other parts. Immediately disconnect the
amp from power source should a spill
occur and dry the amp thoroughly prior
to switching on the amp again. Drying
may require the complete removal of the
chassis from the cabinet and the removal
of the tubes for cleaning. Avoid tipping the
amp, using it in unbalanced positions, or
lifting it unassisted to awkward heights. A
little common sense will go a long way in
making sure the amp does what it’s sup-
posed to do: provide you with dependable
operation and great tone on a consistent
basis.
GROUNDING
Please check thoroughly that the ground
tip on the power cord plug is connected to
true ground prior to operation of your Bad
Cat amp. Using unfamiliar junction boxes
can cause potentially dangerous fl oating
grounds. Please do not cut or defeat the
ground tip.
FOR YOUR RECORDS, YOU MAY WISH TO RECORD THE FOLLOWING INFORMATION.
SERIAL NO._____________________ INVOICE DATE______________________
Last updated: April 1st 2015
LIMITED LIFETIME WARRANTY
Bad Cat Amplifi ers warrantees our amps and cabs against workmanship or defect for
life. The warrantee does not cover tubes or cosmetic damage, or wear and tear or abuse.
This warrantee is transferable. Lifetime transferable warranty is only for North American
sales. Please see your local dealer and distributor for warranty information. Modifying or
altering the amp in any way voids the warrantee. Shipping to and from the warranty repair
center is the responsibility of the customer.
We have a new Lifetime Warranty on all new amps leaving the factory. We are extending
the Lifetime Warranty to all of our pre acquisition amps for $249. Simply send the unit
back to us and we will have one our technicians go through it from the ground up. And to
top it all off, we will pay for the shipping back to you. For more information please contact
us at [email protected] or directly at 800-730-0966.
When RETURNING merchandise to the factory, you must call for a return authorization
number.
HELP SECTION
1) AMP WILL NOT TURN ON
Check the power to the amp. Check for tripped circuit breakers, unplugged extension
cords or power-strip switches that may be turned off. Check the fuse. If a dark brownish
color or no wire can be seen within the glass tube, then replace. The amp may be perfectly
fi ne but occasionally a fuse may blow because of high AC voltage surges. After the fuse
has been replaced with the proper Slow Blow value and if the fuse fails again, the amp
will require servicing.
2) NO OUTPUT with POWER light ON
Tubes damaged in shipping will be the primary reason for your amp to not function
properly. Please give us a call to help guide you through this simple repair.
3) KEEP YOUR AMP LOOKING NEW
Use a damp cloth to wipe the controls on the front & rear chassis panels. Wipe the black
vinyl covering with a damp cloth.
IMPORTANT!
FOR YOUR PROTECTION, PLEASE READ
THE FOLLOWING:
WATER AND MOISTURE: Appliance should
not be used near water (near a bathtub,
washbowl, kitchen sink, laundry tub, in a
wet basement, or near a swimming pool,
etc). Care should be taken so that objects
do not fall and liquids are not spilled into
the enclosure through openings.
POWER SOURCES: The appliance should
be connected to a power supply only of
the type described in the operating in-
structions or as marked on the unit.
GROUNDING OR POLARIZATION: Precau-
tions should be taken so that the ground-
ing or polarization means of an appliance
is not defeated.
POWER CORD PROTECTION: Power sup-
ply cords should be routed so that they
are not likely to be walked on or pinched
by items placed upon or against them,
paying particular attention to cords at
plugs, convenience receptacles, and the
point where they exit from the appliance.
SERVICING: The user should not attempt
to service the unit beyond that described
in the operating instructions. All other
servicing should be referred to qualifi ed
service personnel.
FUSING: If your unit is equipped with a
fuse receptacle, replace only with the
same type fuse. Refer to replacement
text on the unit for correct fuse type.
This symbol is intended to alert
the
user
to
the
presence
of
uninsulated
“dangerous
voltage” within the product’s enclosure that
may be of suffi cient magnitude to constitute
a risk of electric shock to persons.
This symbol is intended to
alert the user to the presence
of important operating and
maintenance (servicing) instructions in the
literature accompanying the appliance.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL!
THIS UNIT CONTAINS HIGH VOLTAGE INSIDE!
PHONE 800.730.0966
FAX 714.630.0106
WWW.BADCATAMPS.COM
140 Technology Drive Suite 500, Irvine CA 92618
BAD CAT HOLDINGS LLC. USA
TROUBLESHOOTING
(continued)
be connected to your amplifi er such as effects pedals or rack pro-
cessors. Some of these devices are “amplifi ers” in their own right
with gain and boosted volume levels and they may cause hissing
and unwanted feedback if set too high in front of the amp.
Shut down the amp and check the tubes. Wait for the amp to cool
down. Remove the back panel of the amplifi er.
Avoid handling hot tubes as they can cause severe burns
.
Check the larger output power tubes fi rst by carefully removing the
tube shields or loosening the clamps, and then unseat the tubes
from their sockets but note from which sockets you removed the
tubes. Inspect the integrity of the fi laments in the tubes. If one or
more of these tubes are bad, you will need to replace the entire
set of the power tubes. If all the tubes are OK, you can eliminate
the adverse sounds by swapping the location of these tubes. If
this fails to fi x the problem, you may need to replace the entire
set of power tubes with a new matched set. Use of inferior quality
(unrated) tubes may cause damage to your amplifi er.
You should also check the preamp tubes, especially the fi rst input
stage tube (far right if you’re looking at the amp from the back).
Microphonics (feedback noise that cannot be controlled by turn-
ing down the volume pot on you guitar) indicates a bad preamp
tube(s). You may want to swap the position of preamp tubes to
see if this will fi x the microphonics problem. Preamp tubes can
go bad without warning but can also last many years without any
problem whatsoever.
As you can see when handling tubes, they are sensitive, fragile
and somewhat prone to inconsistencies. Please handle your amp
with care when transporting it. Although your Bad Cat amp is stur-
dily built and designed to take years of rugged use, the tubes are
not. It’s always a good idea to keep extra tubes (both preamp and
output power tubes) handy, especially for performance situations.
An overwhelming majority of minor problems on tube amps are
tube-related and it’s just a matter of swapping one or more out to
have your amp performing like brand new again.
Operating Manual
BOBCAT
5
SINGLE CHANNEL, 5 WATT, 6V6 CLASS A
Introducing the fi rst of its kind.
If you have ever experienced the pleasure of playing a really fi ne vintage single-ended all tube am-
plifi er then you’ll know the feeling. Touch sensitivity, sweet breakup and natural sounding compres-
sion. It changes the way you play – inspiring and pushing you as a player.
We’d like to introduce our newest cat the Bobcat. Hand-wired, single-ended, touch sensitive, fero-
cious and ultra light weight amplifi er.
High and low gain settings allow for spanky clean and snarling tones accessible by the included foot
switch or front panel switch.
ELECTRONICS
Power:
5 Watt Class A
Channels:
1
Controls:
Rip Switch, Gain, Tone, Reverb, Master
HARDWARE
Available Confi guration:
1x12 Combo
Cabinet Material:
Baltic Birch
Speaker Description:
12” Proprietary Bad Cat Celestion Speaker
Impedance:
8 ohms
Power Tubes:
1 - 6V6
Pre-Amp Tube
: 1 - 6SL7
Rectifi er Tube
: Solid State
Shown as 1x12 Combo in Black Tolex and Dark Gold Grill Cloth
