Bitstorm Inc.
Bad Boy Unleashed N
4
www.bitstorm.com
Disconnect power.
Determine the best location for Unleashed. This can be any place conven-
ient or suitable. It is recommended to install centrally in the area where cov-
erage is to be provided. On a boat, near the nav station or by the mast post
are often convenient choices. Unleashed is intended to be mounted in a
protected and secure area, such as below deck on a boat. Double sided
adhesive tape can be used to temporarily mount Unleashed to test a loca-
tion.
Mount the Unleashed such that the an-
tenna will be vertical. Unleashed can be
mounted in any position that allows the
antenna to be vertical (can be pointing
down or up).
Note: Do not use excessive
force when pulling the cable through
conduits, etc. Avoid pulling the ca-
ble’s connector end through conduit.
Do not make sharp bends in the cable.
When changing direction, bends
should never be sharper than the
round edge of a standard screw driver
handle. Avoid the use of a staple gun – if the insulation is pierced, the
cable can be rendered useless. The cable transfers digital data, so
there is no need to remove excess cable. Bitstorm recommends coil-
ing and securing any extra cable.
Chapter 2 - Operation
Refer to Chapter 1 - Installation for connecting and installing your Wi-Fi device.
Step 1
With power applied, verify that both Power and
LAN LEDs illuminate. At this point, all of the Signal
Strength LEDs could be off.
Step 2
Ensuring that Wi-Fi is turned on in your laptop,
select the ‘Bad Boy’ hotspot access point and con-
nect using
WPA
and enter
the default Preshared Key
‘
password
’ (case sensitive
and without the quotes).
You should now be con-
nected. Verify that a con-
nection exists by observing
the Signal Strength LEDs
illuminating on Unleashed.
