Bad Boy Ambush IS, Руководство пользователя, Страница: 24 / 143

15
OPERATING PROCEDURES
Read all of this manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notices, Cautions, Warnings, and Dangers.
PIN AND SERIAL NUMBER LOCATION
Two serial number and manufacture date code plates are on the vehicle. One is placed under the floor mat on the pas-
senger side of the vehicle, the other is located on the frame below the seat wrap.
Design changes take place on an ongoing basis. In order to obtain correct components for the vehicle, the PIN number,
manufacture date code, serial number, vehicle model manufacture date code, must be provided when ordering service
parts.
Improper use of this vehicle could result in severe injury or death. The AMBUSH is a light duty
utility vehicle, NOT an All Terrain Vehicle (ATV).
To reduce the possibility of severe injury or death resulting from loss of vehicle control the follow-
ing warnings must be observed:
When driving vehicle, consider the terrain, traffic conditions and the environmental factors
which affect the terrain and the ability to control the vehicle.
Use extra care and reduced speed when driving on poor surfaces, such as loose dirt, wet
grass, gravel, etc...
Maintain a safe speed when driving up or down a hill. Use service brake to control speed
when traveling down an incline. A sudden stop or change of direction may result in loss of
control.
To prevent loss of control, do not move the vehicle direction selector while the vehicle is in
motion. moving the direction selector will result in a sudden slowing of the vehicle.
Slow down before and during turns. All turns should be made at reduced speed.
Do not drive through water that is over 12 inches deep.To prevent inadvertent movement
when the vehicle is to be left unattended, engage the parking brake, turn key to OFF position
and remove key.
Make sure the key switch/direction selector is set to the Forward or Reverse before attempt-
ing to start the vehicle.
Always bring the vehicle to a complete stop before shifting the direction selector.
Do not take vehicle out of gear while in motion (coast).
Check area behind vehicle before operating in reverse.
All occupants must be seated with seat belts fastened and front side nets latched. Keep
entire body inside vehicle and hold on while vehicle is in motion.
PIN LABEL
SERIAL NO. PIN AND SERIAL NO.
Front of Vehicle