ANT00517K01
IMPORTANT!! PLEASE READ ENTIRE INSTRUCTION SHEET BEFORE ASSEMBLY!!
TO EXPEDITE ANY FUTURE WARRANTY CLAIMS, PLEASE KEEP INSTRUCTION SHEET, WARRANTY CARD, AND RECEIPT.
Page 2
Step 5:
Note:
Do not over tighten
After making any necessary adjustments to the
alignment of the table top, use the hex bolt driver to
tighten all bolts.
each bolt must be tightened a
few revolutions at a time. In order to apply equal
pressure to all bolt joints, we recommend working in a
cross corner (X fashion). Repeat until all bolts are tight.
. Over tightening may strip bolts.
Cover all bolts and nuts with covers.
With the help of another person, turn the table in the
upright position. Your table is now ready for use. If you
have any questions, please call our Customer Service
Center at 1-800-416-3511.
Step 6:
IMPORTANT NOTE: Damage to welds or frames resulting
from over tightened bolts or improper assembly is not covered
under our warranty. Please read all instructions carefully
before assembly. If you have any questions regarding your
assembly, call our Customer Service Center at 1-800-416-3511.
Step 1:
Do not attempt
assembly if any parts are missing or damaged.
Remove all protective materials and set parts on a flat,
non-abrasive surface. Identify the parts packed in the
carton against the parts list. If you are missing any parts or
unsure how to proceed with assembly, call our Customer
Service Center at 1-800-416-3511.
Step 2:
Hand tighten
only 2-3 turns.
Attach three table legs to the table top by using six
bolts and Ø20xØ6.5x2.0mm washers as shown in
. Guide the bolts through the holes in the leg
into the pre-drilled holes in the table top.
F
1
Place the table top upside down on a flat, non-abrasive
surface.
igure
8
HW0594
Ø
X
20
Ø6.5 X 2.0 MM
WASHER
PARTS LIST
DESCRIPTION
ORDER PART # QTY
1
A
B
C
D
E
F
G
H
I
J
K
1
BOLT COVER
TABLE LEG
LEG CONNECTOR
BAR
HW0105
HW0004
HW0006
FOOT CAP
FACTORY ASSEMBLY
1
* NOTE: PARTS SHOWN ON PARTS LIST ARE NOT TO SCALE
Ø6.5 X 1.0 MM
WASHER
FC0607
1/4" X 30 MM BOLT
HW0038
8
4
TABLE TOP
8
HW0009
1
NUT COVER
HW0027
8
1/4" NUT
HW0014
8
HEX WRENCH
G0157
UMBRELLA HOLE
PROTECTIVE RING
FACTORY ASSEMBLY
HEX BOLT DRIVER
8
Step 3:
Attach three legs to the leg connector bracket by carefully
guiding the bolts already in place on the table legs
(each leg has two bolts) through the holes in the leg
connector bracket. Add a washer and a nut to the end
of each bolt as shown in the
.
F
2
Hand tighten
2-3 turns only.
igure
AT53120
AT53121
AT53122
Figure 1
FOOT CAP
A
C
D
F
I
B
G
E
H
Figure 3
Step :
Repeat above process(
& 2) for the last leg as
shown in the
.
4
Figure 1
F
3
igure
C
Figure 2
