MR 1532 (1P) Tank Locomotive
Owner’s Information
Many thanks for purchasing one of our Bachmann Branchline MR 1532 (1P) Tank Locomotives. A lot of care was
taken producing your model and we hope you enjoy it for many years to come.
2. Accessories
E3174 Instruction Sheet
It is necessary that this Locomotive is ‘run-in’ to allow the mechanism and gears to settle. This requires the model
to be run without a load (wagons, coaches, etc.) for 30 minutes in each direction at half speed.
3. Running-in
1
2
1
2
3
3
4
4
fig.1
fig.2
1 Steam Heat Pipe*
2 Screw-link Coupling*
3 Cab Steps
-
For display purposes only
4 Cab Doors
5 Next18 DCC Blanking Plate
- Supplied with SOUND
FITTED models only. Can be used to replace the Sound
Decoder for use on analogue control without sound effects.
* Only fit if Standard Coupling has been removed.
Motor Type: Coreless
DCC Compatibility: Next18 Decoder socket in Body (SOUND FITTED models come pre-fitted with Sound Decoder)
Recommended Decoder: Bachmann 36-567 Next18 DCC Decoder
Speaker: Factory Fitted to all models (0.7/1 Watt / 8 Ohm)
Electrical Pickup: All Wheels
1. Locomotive Information
5
fig.3
Although our models are highly detailed and ready to run straight from the box, we also supply optional
accessories to be fitted by the owner if they wish. Some of the accessories should only be fitted for static display
as they may affect coupling or running quality, these parts will be labelled as such below.
Please note: PVA based adhesive should be used for the fitting of accessories.
Please note: This model has been designed to run on curves of no less than 2nd Radius (438mm). We recommend
that you don’t use anything smaller as this may result in the model derailing.
For analogue use we recommend using a controller with a smoothed output. If you have any doubts please
consult the controller manufacturer before operating this model. Do not use with Electronic Track Cleaners.
