Dynamis User Guide
21
- remove all other locomotives from the track whilst programming
Or:
create an isolated section of track to be a separate Service Track. Either disconnect
your Dynamis Command station from the layout and connect to short length of
track, or create separate block section on the main layout that can be separated
from the remainder with a switch.
What is the rating of the track power?
The voltage is stabilised at 15.5v ± 5%, with 2.3 amps of power.
How to use one Dynamis system in proximity with another
So that multiple Dynamis systems can be used in proximity, there are 4 infra-red
signal channels available. The default setting of 0 should not be changed unless
necessary to avoid a conflict with another Dynamis system in use in close by. Set the
jumper plugs to the pins below the unit to use channels 1, 2 or 3 instead of 0, to
match the channel set on the Handset. The pins are marked under the unit. Channel
0 uses no jumper plugs.
Safety and care of your Dynamis
Use under adult supervision.
Only use the supplied power supply, taking care with the power lead. The
appropriate mains pins for the local electricity supply requirement should be fitted
by an adult: THE MAINS TRANSFORMER AND ITS PINS ARE NOT A TOY. Do
not use if the cable becomes damaged. Contact a Bachmann Service Department
should a replacement power supply be required.
