8
sible areas, to achieve optimum
results.
3. Switch the shaver off each time
after shaving and clean it.
4. Do not push the shaver on the
skin too hard as it could cause
irritation, make the shaver warm
and prevent a perfect shave.
5. Please note that it takes 2 to 4
weeks for your skin to adapt to a
shaver, so please do not change
shaving instruments in this pe-
riod of time.
6. If hair is longer than 1mm begin
by cutting the hair down first
with a trimmer, than use shaver
for a smooth close shave.
USER MAINTENANCE
INSTRUCTIONS
TAKING CARE OF YOUR SHAVER
Do not remove the shaving foil unit
while the shaver is switched on.
Always switch the shaver off!
Ensure that no water gets into the
inside of the shaver to avoid the risk
of an electric shock when it is back
in operation.
Never press on the cutting blades
or the shaving foil and do not touch
them with hard objects as this can
cause irreparable damage to the
shaver or parts.
Be careful when dealing with the
blades, as they are very sharp. Risk
of injury!
When cleaning, do not apply any
detergents or scouring agents and
do not use any abrasive or sharp
objects. They can cause irreparable
damage to the shaver.
NOTE: When cleaning your shaver,
make sure the unit is turned off.
CAUTION!
• DO NOT run shaver or cutters un-
der water. Use only the small brush
(included) to clean.
• To clean the external surfaces of
the shaver, use a damp cloth. Do
not use strong detergents or other
chemicals.
• To dry, wipe the surface of the sha-
ver with a dry towel. Do not use
a hair dryer or heater to dry the
shaver.
• The shaver should not be used
until it has completely dried.
DO NOT USE A VOLTAGE
CONVERTER.
TO REPLACE FOIL HEAD ASSEM-
BLY
1. Remove the foil head assembly
by pressing the round release
button located on the side of the
shaver. Hold the foil head assem-
bly on both sides and lightly pull
away from shaver unit.
2. Take the replacement foil head
assembly out of package. Align
the replacement foil head assem-
bly over the cutters. Carefully
move the replacement foil head
assembly down towards the sha-
ver unit until it firmly snaps into
place. BE CAREFUL NOT TO DA-
MAGE THE FOILS OR CUTTERS
WHILE INSTALLING.
