Baby Lock BLMY, Руководство по обслуживанию

Страница: 107 / 226

3 - 28
Electrical parts and motors Main unit
12
Power supply unit F attachment
1. Attach the power supply unit
1
to the arm bed with the 3 screws
1
.
2. Connect the inlet assembly lead wirefs connector
2
to the power supply
unit.
3. Connect the main motor assemblyfs connector
3
to the power supply unit.
1
Torque
0.78 – 1.18 N·m
1
3
2
1
Screw, Pan (S/P washer)
M4X14
13
Wire assy. and knee lifter assy. attachment
1. Attach the fitting
1
on the end of the wire assy. (side with two M8 nuts on
it) to the wire holder
2
on the knee lifter assy., and hand tighten the M8
nut
3
on the lower side.
(Fully tighten after 4 - 21"Knee lifter adjustment.")
2. Attach the hook
4
on the end of the wire assy. to the knee lifter assy. shaft,
and attach retaining ring E3.
3
4 Retaining ring E3
1
2
14
PBC unit LED lamp-FL attachment
1. Attach the PBC unit LED lamp-FL
1
to the needle-presser module using
the screw
1
.
1
Torque
0.78 – 1.18 N·m
1
1
Taptite,Pan B
M 4X12
15
Wire clip attachment
1. Attach the 4 wire clips
1
to
4
with the 3 screws
1
.
*Key point
• Secure wire clips 2 and 3 with one screw 1 .
1
Torque
1.47 – 1.98 N·m
1
1 4
2 3 1 1
Taptite, Bind S
M 4X10