Upper Looper
1. With the presser foot up and threading lever in the threading position. ( fig. A, page 17)
2. Place the thread cone or spool on the second spool pin on right side of the thread stand. (fig.C)
Slip the thread into the telescopic antenna thread guide “A” directly above the spool, snap into the pre-
tension thread guide “B” at the top of the machine, then through the slot on the front of the machine.
(fig. C)
3. Pull 18 inches (45cm) of thread through guide “C”.
Insert the end of the thread into the threading port “U” about 1/2 inch (1.2cm) .
Us e t w eez ers if nec es s ary, t o ins ert t h e t h read end m ore eas ily.
4 . P us h t h e t h read ing b ut t on.
I f t h e t h read d oes not g o t h roug h t h e upper looper eye w it h one pus h , t h en pus h t h e t h read ing b ut t on
again until it does. *(fig. D)
5 . P ull t h read t ow ard t h e rear of m ac h ine and plac e und er t h e pres s er f oot .
6 . O nc e m ac h ine is c om plet ely t h read ed f or c h os en s erg ing applic at ion, s et t h e t h read ing lev er t o t h e
s erg ing pos it ion.
Note:
D iag ram s C and D b elow are illus t rat ions f or t h read ing low er and upper loopers .
*Be sure at least 1/2” of thread is inserted into the threading port.
C
2
3
B
A
1
L
R
L
R
2
B
C
2
3
B
A
1
L
R
L
R
2
B
1/2
″(
1.
2c
m
)
18
″(
4 0
c m
)
P us h T o T h read
Loopers Button
P ret ens ion
Thread Guides
C
D
1 8
T
H
R
E
A
D
I
N
G
