User Tips
Daily Cleaning
Monthly Cleaning
The Funnel, Funnel Cover and underside of Powder Container MUST BE CLEANED once per day
(if machine is used daily). Follow these steps to clean the Formula Pro® parts every day.
Remove Funnel & Funnel Cover
by pulling out and down.
Wipe the hole the on underside of
Powder Container.
The Powder Container parts, Water tank and Base should be cleaned once a month.
With the Funnel removed and Powder Container attached to machine,
wipe any dry formula powder from the hole on the underside of the
Powder Container & Funnel Compartment in a circular motion with a
DRY paper towel or DRY soft cloth.
Always make sure the Funnel and Funnel Cover are completely DRY
before placing in machine.
Remove Funnel Cover from Funnel
by lifting up on Funnel Cover.
Wash and rinse Funnel & Funnel Cover
thoroughly.
Unplug the appliance before cleaning. Do not use abrasive pads to clean the machine.
Funnel and Funnel Cover are top rack
dishwasher safe and are also safe for
steam sterilization.
Never use a wet or damp cloth to clean the Funnel Compartment
or underside of Powder Container.
The Formula Pro can be used at any time during the water heating cycle, but not all powders mix well with cool
or room temperature water. Always check for clumps & shake or stir the closed bottle gently to mix the powder
completely with the water.
ALWAYS FOLLOW INSTRUCTIONS AND NOTE EXPIRY DATE ON POWDER MANUFACTURER LABEL
7
8
1
4
2
3
1
2
3
Refill Water Tank regularly with room temperature water and keep
machine powered on. This way, the water will always be warm and
ready to serve.
Do not remove the Water Tank from the base to refill. Simply lift the
Water Tank Lid at the front and pour water in. Make sure to keep
water above “MIN” line.
To easily separate the Upper Measuring Wheel from the
Lower Measuring Wheel, press the raised center area while
holding the outside edge as shown in photo at right.
If the powder forms a cone shape
mound when refilling the Powder
Container, use the 3 arms on the
bottom of the Powder Container
Lid to gently level the powder
before closing. Always keep
the powder level below the MAX line
and never pack powder in the
Powder Container.
The machine Base should be wiped
with a damp, soft cloth or sponge
and dried immediately. Never
submerge the base or plug in water
or other liquids. Dry machine Base
after cleaning.
The Water Tank
should be cleaned
once a month
with mild detergent
and soft cloth or
sponge. Rinse inside
of Water Tank
thoroughly before
refilling with clean,
purified water. Wipe
the outside of the
Water Tank with a
damp clean cloth.
Never immerse Water Tank or get
the electronics in the base of the
Water Tank wet. If the electronics in
the base of the Water Tank get wet, allow
to air dry thoroughly before placing back
on base. Never place Water Tank in
dishwasher.
The Powder Container and Powder
Container Parts should be cleaned
once a month by emptying any
remaining powder (powder can be
saved for refill) and cleaned with mild
detergent and soft cloth or sponge.
Never place Powder Container in
dishwasher.
Always make sure powder level is above the top of the Stirring Wheel.
You will know it’s time to refill the Powder Container when any of the
four horizontal arms of the Stirring Wheel are visible through the
powder.
Do not use the machine when the powder level is below the MIN
line marked on the Powder Container.
Refill when arms of stirring
wheel are visible
Make sure
powder is
not above
the MAX line
before closing
lid.
Make sure
powder is
not above
the MAX line
before closing
lid.