ENGL
ISH
DE
UTS
CH
FRANÇAI
S
NEDER
LAND
S
System On and Off
When the system is off, press the ‘ON/OFF’ button to turn on the system. To turn off the system, press the ‘ON/OFF’
button for 2 seconds to turn it off. This will only function if the display is connected to the controller and battery.
If the display is turned off while riding the battery, it is possible that random values are displayed as the motor
generates small powerstreams. If that happens, everything that is shown when the system is not activated can be
ignored. The display and system will automatically shut down if the speed is 0 km/h and not used for 10 min.
Selecting Menus
Pressing the ‘SET’ button allows you to rotate between the following options: odometer (ODO), trip distance
(TRIP), distance to go (TRIP to GO), and time to go (TIME to GO).
Odometer
Shows the total distance traveled by the bike since manufacturing.
Trip Distance
Resets whenever the system is turned on or when the user manually resets it via the settings menu. It shows the
distance traveled for the current trip.
Distance To Go
The approximate distance the bike can go before running out of battery, based on the current battery capacity
level and current motor assistance mode.
Time to Go
The approximate time remaining on the bike before running out of battery, based on the current battery capacity
level and current motor assistance mode.
Adjusting Motor Assistance
The ‘PLUS’ and ‘MINUS’ buttons will allow the user to select the different motor assistance levels for the bike.
This varies from 0 to 8, 8 being the strongest assistance. At level 0, the motor provides no power, but the display
of the bike is still usable with all functions available. The battery will run out of power faster when using a higher
level than a lower level. Levels 1-5 are appropriate for flat roads, while level 6-8 are much stronger and only
meant for hills, slopes, and tough circumstances.
Controlling Walk Assist
Using walk assist of the bicycle helps the user more easily walk the bicycle. When the ‘PLUS’ button is held down,
the ‘6KM’ icon will appear on the display, and the bike will start moving at 6 km/hr. When the ‘PLUS’ button is
released, the walk assist mode will end and the motor will no longer provide the 6 km/hr speed. When using walk
assist, keep your hands on the handlebars and the brake lever in case its needed.
Display Backlight
When the system is turned on, pressing the ‘ON/OFF’ button will toggle the backlight of the display to on or off.
Settings Menu
When the system is turned on, holding down the ‘SET’ button for over 3 seconds will enter the settings menu.
Once inside, there are 2 options, SET 1 and SET 2. Pressing the ‘SET’ button will switch between them. To exit the
settings menu, press and hold the ‘SET’ button for over 2 seconds.
Set 1: Reset Trip Distance
In the settings menu, option SET 1 is to reset the trip distance to 0, pressing the ‘MINUS’ button should result in
resetting the trip distance to 0.
Set 2: Metric or Imperial Selection
In the settings menu, option SET 2 is to change the units between metric (KM/H) and imperial (MPH), pressing
either the ‘PLUS’ or ‘MINUS’ buttons will alternate between the 2 settings. Once the desired units are selected,
press ‘SET’ to save the setting.
“With the electric Babboe Carve,
always the wind behind you”
25
24
