DUO
DMX
GATEWAY
DUO
DMX
GATEWAY
BAB TECHNOLOGIE GmbH 39
5.5.2.2
GROUP ADDRESS CONNECTION
Once the group addresses are available (see below). They can be used to connect the different DMX
channels of the DMX interfaces. The created scenes are provided in the
Scene out
tab, the DMX
channels are provided in the
Dimmer out
tab and the defined DMX lamps are provided in the
Device
tab.
CONNECTING THE SCENES (
SCENE OUT
)
All scenes created in the
DMX-Configurator
are listed in the
Scene out 1
and
Scene out 2
tabs. The
scenes can be connected with the following data types:
1 bit: DPT 1.001 (EIS 1 Switch), value: [0.1]
Scenes are started by telegrams with the value “1” and stopped or interrupted by the telegram value
“0” (see
chapter “
LAN/KNX
”
).
To create a connection, please proceed as described below:
Simply drag the desired group address from the address tree at the left side to the
corresponding scene at the right side. Then the group address is illustrated below the scene.
(see figure below)
Figure 36: Connecting the group addresses with the scenes
Each scene can be started with any number of group addresses. All relevant addresses are dragged to
the scene.
Note: The program automatically checks for the connection whether the selected group address
has the correct data type for the communication object. If this is not the case, the connection is
not possible and the group address cannot be connected.
