DUO DMX
Gateway
Put it into Operation
DUO DMX
Gateway
b.a.b-technologie gmbh 11
Now switch back to the window of DMX-Configurator and mark the desired device in list “DMX-
Gateways”. By clicking “Upload” the current settings out of the DMX-Configurator will be
transmitted to the DUO DMX Gateway. A successfull transmitting is been confirmed with the
message “Upload done”. If not you will get an error message. In this case please check the
network settings of your PC and the DUO DMX Gateway once again.
Figure 11: DMX-Configurator - transfer configuration
After that please leave the window “KNX” or “EnOcean” by clicking the “OK” button and save
the current setting with the help of the menu “File” – “Save as” as project file “*.dx1”. Please
use this project file later for the further project settings.
Figure 12: DMX-Configurator – save project
Advice: If you want to use a new project file, please consider the IP-address settings. Every new
project contain the default IP-address settings again. With uploading data of a new project once
again the device would set back to the default IP-address settings.
